Newark Resurfacing a Concrete Driveway- An Info

You can note that the concrete driveway creates gaps in it over time, this is largely the result of the elements and the wear and tear of working on it. Once you had holes in your road in the past the only way to repair them was to break it and paint a new surface. This is no longer necessary as the cracks can be filled and the driveway resurfaced relatively easily. It’s a task you should be able to do alone to help keep the cost down.You may want to check out Newark driveway resurfacing for more.

Rockford Decorative Concrete, Rockford Stained Concrete Contractor ...

The first thing you want to do to resurface your driveway is ensure you clean it up. For the resurfacing to be successful, the driveway needs to be clean. The best way to ensure you get it clean is by using a pressure washer. If you have any oil stains on your driveway, a degreasing agent is required to get them off. It is also important that the cracks you plan to fill are cleaned out. Scrape them out as best you can, and add a little bleach into the opening. Taking your pressure washer after about ten minutes, then wipe the cracks away.

To cover the holes you’ll want to use a concrete dressing. You can use a putty knife to push the dressing down into the crack for small cracks, and you will find a caulking gun works better with larger ones. In either scenario after covering the holes use a putty knife to smooth out the coating.

Once the holes have been filled, you will have to cover the joints for growth. These are the lines which separate the concrete in parts of your driveway. We are there for the asphalt to be able to expand and compress as the weather changes. You need to secure these expansion joints in position so you want to cover them with duct tape.

The next stage is to combine the concrete dressing; for this, you’ll want to follow the instructions on the package. You’ll need someone to support you, unless you’re just doing a very small area. The concrete must be blended in small batches and quickly applied. You will need to have one person add the concrete dressing for a driveway while the other mixes the next sample. Before the dressing starts to dry you want the whole driveway sealed.

You will want to spill it onto the surface to cover the concrete coating, and then wash it out. If you do just a small area the best way to do it is with a trowel, a long handled squeegee is the best bet for large areas. In either scenario make sure you push hard to get the concrete dressing into all the crevices, this will mean you have a good smooth surface.

You don’t want the asphalt to be shiny when you are resurfacing a road, the driveway should have depth to it. The way you do this is to take a push broom with a bristle and drag it over the concrete dressing while it is still warm. This will ensure a textured surface is obtained that is slip resistant.