The success of injectable fillers has prompted us to accept and use their placement far down to the bone below the skin surface. In fact, applying an injectable additive to the bone. It sounds appropriate for the cheek and chin region, and can really be achieved from a technological point of view. The problem is … is it really a smart idea? Get more info about Toorak cheek filler.
In the past, I used particulate matter ‘injectable’ for facial bone augmentation. Around the time I sometimes used collagen (avitene) powdered hydroxyapatite granules to create an injectable paste. That was achieved through minor incisions for cheek and lip regions within the jaw, except sometimes for certain slight flaws in the forehead. The applied paste was mainly hydroxyapatite granules that are relatively permanent and do not melt and go down, and that the body embraces very well. Throughout fact, they are incorporated on top of the bone within the mark that grows, becoming a kind of part of the bone through a gradual cycle of augmentation.
Yet today’s injectable fillers aren’t universal and can go down, some sooner than most. Most relevantly, though, the sheer amount of material it requires to create a change at bone level is important. You have to apply between 3 to 5 ccs at the bone level to really create a visible difference on the outside of the nose. You will easily see that an injectable bone augmentation filler solution is cost prohibitive and a very poor benefit, because it is not permanent. New silicone implants, or also old-style hydroxyapatite pastes, are far more effective and are a greater value for money, even if it needs surgery.